RTS XCP-ADAM-MC Servisní příručka stáhnout pdf (Strana 43)

Adding or Removing a GPI Output Key Assignment

1. Select

, then tap

PGM

displays.

3. Press

↓↓

to display

4. Tap

PGM

displays.

6. Press

↓↓

↑↑

to display a different GPI output.

7. Tap

PGM

to select a GPI output.

displays. Also, if there is a key currently assigned to activate the selected GPI output, both

LEDs for that key will be lit red. If there is no assignment, no LEDs will be lit red.

9. Tap an intercom key to add or remove the GPI output assignment.

10. Tap

CLR

to exit, or

BACK

to back up and make more assignments.

11. Run Service Menu, Save Cfg, page 44, to store local GPIO settings.

Service Menu, Mic Preamp

This menu item works with the optional Connector Module. It turns the Mic Preamp output connector on or

off.

1. Select

, then tap

PGM

2. Tap

PGM

to turn the preamp on or off.

→

indicates that the preamp is on. (without

the arrow) indicates that the preamp is off.

3. Tap

CLR

to exit

4. Run "Service Menu, Save Cfg", page 44, to store the new preamp setting.

Service Menu, Mod Assign

☞

Normally, this is a service adjustment that is required only when replacing a key and display module. It

may also be required if for some reason, the key assignments, as displayed in ADAMedit, appear to be

in the wrong positions on the keypanel or expansion panel.

The KP-32 and EKP-32 use module ID numbers (Mod ID numbers) to define the address of each key and

display module. See Figure 5. By default, Mod 1 is always assigned to the right half of the KP-32 and this

never changes, since this module has the keypad and is unique. However, the rest of the modules are

identical. When replacing any of these modules, you may have to reset the Mod ID number as follows:

1. Select

from the Service menu and tap

PGM

displays. To exit the procedure without making changes, tap

PGM

3. All of the alphanumeric displays, except Mod 1, will appear as shown in Figure 5. Assign the Mod

IDs as shown in the figure. Repeat the procedure for each module.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 57 58

Komentáře k této Příručce

Žádné komentáře

RTS XCP-ADAM-MC Servisní příručka Strana 43

Komentáře k této Příručce

Související produkty a manuály pro Systémy intercom pro domy RTS XCP-ADAM-MC