RTS XCP-ADAM-MC Servisní příručka stáhnout pdf (Strana 14)

Continuous Red Talk LED ("In-use"):

The key is off, but someone is talking to the destination. This

indication is provided for any local PL, IFB, ISO, or TIF key. It does not apply to remote IFB or ISO keys.

This indication is provided so keypanels operators know when critical director communications are

occurring. If you activate the key, either of two things will happen:

•

If you activate the key and the talk LED turns continuous green, this indicates that you and the other

keypanel operator are both talking to the destination.

•

IFB keys only: If the talk LED flashes red when an IFB key is activated, this indicates that the other

keypanel has a higher IFB priority and you cannot talk at this time.

☞

The red "in-use" indication for TIF keys can be disabled in ADAMedit: In the ADAMedit Options

menu, select Intercom Configuration, then click on the Options tab. Place a check mark next to "Don't

generate talliesfor TIF and trunk use". Be sure to send the change to the intercom system. Note that

this will also disable the flashing alpha display when talking to remote IFBs or ISOs as previously

described.

Flashing Red Talk LED ("Busy"):

You cannot talk at this time. This indication occurs when you activate

a local IFB key that is already in-use by a keypanel with a higher IFB priority. It also occurs when you

activate any key assigned to a remote destination, but there are currently no trunks available.

☞

Note: Flashing red is also the intended indication when attempting to talk to a remote IFB while

someone else with a higher trunk IFB priority is already talking. However, this will require ADAM

MC version later than 9.9.x and Trunk MC version later than 7.x.x. As of this writing, these versions

are not implemented. Regardless of the indication provided, you will not be heard at the remote

location if your keypanel has the lower trunk IFB priority. IFB trunk priorities are set in ADAMedit.

(Click the "KP" button on the ADAMedit toolbar to access Keypanels / Ports setup, then click the

"Edit" button, then click the "Advanced" tab. Enter the desired IFB priority in the fields provided. Be

sure to send the change to the intercom system.)

Flashing Green Talk LED (on time equal to off time):

There is an incoming call from the destination

assigned to the key. Activate the key to talk back.

☞

The duration of incoming call flash is controlled by DIP switch 4 on the KP-32 back panel. See

"Option Switch Settings", page 9 for further information.

Winking Green Talk LED (on time less than off time):

This indicates that a key is ready to talk (key is

on), but requires external footswitch activation to talk.

☞

"Switch 5: Footswitch Enable / Disable", page 9.

Listen LED Indication

The listen LED is the upper LED for each key. The listen LED is green when listen is on.

Intercom Key Operation

Basic Intercom Key Operation

The "up" position of an intercom key activates listen (if assigned). The "down" position activates talk (if

assigned). If there is no talk assignment for an intercom key, the talk position of the key will not activate. If

there is no listen assignment, the listen position will not activate.

For momentary activation of a key press and hold the key. Then, release it when finished.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

Komentáře k této Příručce

Žádné komentáře

RTS XCP-ADAM-MC Servisní příručka Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Systémy intercom pro domy RTS XCP-ADAM-MC