RTS XCP-ADAM-MC Uživatelský manuál stáhnout pdf (Strana 33)

CHAPTER 4

RVON-C Quick Start

This guide explains briefly how to install and configure an RVON-C card in a Cronus system. It contains the following

sections:

1. Install the Front card and the Back card into Cronus

2. Connect Ethernet

3. Connect to Cronus frame in AZedit

4. Configure the RVON-C card

5. Configure the devices the card will connect with.

6. Begin Operation.

NOTE: If you are connecting using Serial Pass-Through Port, “Setting up a Serial Pass-Through Port Connection or

Serial Connection” on page 35

Install Front and Back Cards in Cronus

When inserting the RVON-C card into Cronus, the following considerations need to be made:

• Gently insert the RVON-C card into the correct slot. If the card is forced or twisted while inserting, a pin on the

backplane could short or break causing the card to become inoperable.

• When inserting the RVON-C card into Cronus, be sure to insert it into a compatible backcard. If the card is

inserted into an incompatible backcard, undesirable results can occur.

Plug in Ethernet

Verify that there is an Ethernet connection from the RVON-C card (J2 Ethernet on the back of the Cronus) to the network.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 58 59

Žádné komentáře

RTS XCP-ADAM-MC Uživatelský manuál Strana 33