RTS XCP-ADAM-MC Uživatelský manuál Strana 32

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 59
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 31
30
RVON-C Default Setup
Every attempt is made to ensure the board is shipped from the factory containing the following:
All are “set rvon” commands
There are more parameters that the software will auto-configure if they have not been previously setup. The user can also set
these parameters, in which case the software would not modify but take them as they are.
All are “set chan #” commands because they are for each audio channel.
Typing, “pintenv”, then pressing Return from an RVON-C boot code or “sys-printenv” from the MXP Debug System Prompt
may show these commands. The Environment name is listed because this is the label used by the software
IMPORTANT!: If the user is attempting to do a “setenv” to change a parameter from the RVON-C boot code, the
Environment Name must be used and NOT the “set rvon variable” name.
show channel
[chan]
Display current settings
show emac Display current settings
VARIABLE ENVIRONMENT NAME DEFAULT
VA L U E
DESCRIPTION
ip_addr EMACA_IPADDR x.x.x.x IP Address for the RVON-C Card
netmask EMACA_NETMASK 255.255.255.0 Network Mask for the RVONC card
gateway EMACA_GW none Gateway IP Address for the RVON-C Card
serial_ip RVON_SERIAL_IP none Pass-thru serial port IP Address for the RVON-C Card
serial_baud RVON_SERIAL_ Baud 9600 Set the pass-thru serial port baud rate for the RVON-C Card
user RVON_USER telex RVON-C user name for telnet access
password RVON_PASSWORD password RVON-C password for telnet access (8-40 characters)
vad_threshold RVON_THRESHOLD_VAD 10 VAD Threshold
VARIABLE ENVIRONMENT NAME DEFAULT
VA L U E
DESCRIPTION
dest_ip RVON_DEST_IP_# X.X.X.X Destination IP Address for this particular RVON_CH
dest_type RVON_DEST_TYPE_3 X Destination Type Y= 0 (RVON-C), 1 (rvon-1), 2 (rvon-I/O)
dest_chan RVON_DEST_CHAN_# X Destination Channel - what port of far end (0-7)
chan_codec RVON_CHAN_CODEC_# X Profile to use (previous coding table)
TABLE 3. Serial Command Table
Command Variable 1 Variable 2 Description
Zobrazit stránku 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 58 59

Komentáře k této Příručce

Žádné komentáře