RTS Cstrunk Specifikace Strana 53
- Strana / 104
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
47
5. Run Service Menu, Save Cfg, to store the Preamp Out settings.
Service Menu, Reset Cfg
Reset Cfg restores all custom settings to the defaults and erases all stored autodial numbers.
Service Menu, RVON Setup (RVON Option Only)
RVON Setup is used to configure the IP Address, Netmask Address, and Gateway Address for the RVON device you want to
use.
To configure the RVON device on the keypanel, do the following:
1. Select RVON Setup, then tap PGM.
IP Address appears.
2. Tap PGM.
Enter IP Address appears in the keypanel display.
3. Using the keypad, enter the IP Address.
Use the PGM button as the dots between octets.
4. When finished entering the IP Address, press PGM.
Netmask appears in the keypanel display.
5. Using the keypad, enter the Netmask, if necessary.
Use the PGM button as the dots between octets.
6. When finished entering the Netmask, press PGM.
Gateway appears in the keypanel display.
7. Using the keypad, enter the Gateway, if necessary.
Use the PGM button as the dots between octets.
8. When finished entering the Gateway, press PGM.
9. Tap CLR to exit.
10. Run Service Menu, Save Cfg. to store the RVON Setup settings.
Service Menu, Save Cfg
Save Cfg saves custom settings that you have made in the Key Option or Service menus. made in the After customizing
settings in the Key Option and Service menus, run Save Cfg to store your custom settings in non-volatile memory. This will
assure protection of you settings when the keypanel is powered down. To erase all custom settings, run Service Menu, Reset
Cfg.
Service Menu, Scr Saver
The Scr Saver menu item is used to configure the operation of the screen saver on the keypanel.
The following options are available to configure the screen saver:
Delay - By default, a one (1) hour delay is programmed. You can choose 30 min and 1 to 12 hours (available in one
(1) hour increments).
Display Off - Display Off turns the display off without diplaying the screen saver. Press any key to activate the display
window.
Activate - When selected, Activate enables the screen saver immediately. Press any key to activate the display window.
- USER INSTRUCTIONS 1
- Contents 3
- Introduction 9
- GPI Connector Module 10
- EKP-632 Expansion Keypanel 11
- LCP-632 Level Control Panel 11
- MCP-90 Panel Microphone 12
- Headsets 12
- Installation 13
- Address Switch Setting 14
- Address Setting for Zeus 15
- Address Setting for ADAM CS 15
- Connections 16
- Power Supply Connector 17
- Headset Connector 17
- Panel Microphone Connector 18
- Basic Operation 19
- Intercom Keys and Displays 20
- Listen LED Indication 21
- Intercom Key Operation 22
- Muting the Microphone 23
- Call Waiting Operation 24
- Telephone Operation 25
- KP9X Redial Sequence 26
- KP9X Autodial Sequences 26
- Manual Dialing 27
- Autodial 28
- Display Panel ID 29
- > Tap CLR to quit 29
- 1. Tap the E-PNL key 32
- 3. Tap the PGM key 32
- • Tap COPY 35
- Clearing a Key Assignment 35
- KP-632 Menu System 37
- Menu System, Key Assign Menu 39
- Key Assign Menu, Matrix 40
- Key Assign Menu, Pt-to-Pt 40
- Key Assign Menu, Party Line 40
- Key Option Menu 43
- Key Option Menu, Key Groups 44
- Key Option Menu, Solo 44
- RVON Conn. Menu 45
- Service Menu 45
- Service Menu, Baud Rate 46
- Service Menu, Dim 46
- Service Menu, Disply Dim 46
- Service Menu, Hdst Sel 48
- Service Menu, LCD Bright 48
- Service Menu, Matrix Out 51
- Service Menu, Mic Select 51
- Service Menu, Min Volume 51
- Service Menu, Mod Assign 51
- Service Menu, Output Level 52
- Service Menu, Reset Cfg 53
- Service Menu, Save Cfg 53
- Service Menu, Scr Saver 53
- Service Menu, Sidetone 54
- Service Menu, Snoop Tally 54
- Service Menu, Test Panel 54
- Service Menu, Tone Gen 54
- Specifications 55
- Speaker Amplifier and Speaker 56
- KP9x Display Sequences 63
- KP9x Setup Page Assignment 64
- KP9x Phone Operation 65
- Menu Access 67
- Menu List 68
- Mode 2 Operation 69
- Glossary 71
- Features 77
- Dip Switches 79
- Addresses and the RVON-1 82
- Top Level Menu, Rvon Conn 84
- Basic Network Configuration 87
- Wide Area Network 89
- TABLE 4. Packet Translation 90
- TABLE 5. Packet Translation 90
- IP Addresses 92
- Ping a Computer 93
- RVON Configuration 95
- Network Terminology 96
- • Backcard DB-9 J2 98
- Press Enter 100
- 3. Press Enter 101
Související produkty a manuály pro Systémy intercom pro domy RTS Cstrunk
Systémy intercom pro domy RTS CIF-612 Specifikace
(72 stránky)
(72 stránky)
Systémy intercom pro domy RTS TR-240 Specifikace
(86 stránky)
(86 stránky)
Systémy intercom pro domy RTS XCP-24 Servisní příručka
(114 stránky)
(114 stránky)
Systémy intercom pro domy RTS TR-240 Specifikace
(20 stránky)
(20 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce