RTS Cstrunk Specifikace Strana 46
- Strana / 104
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
40
Service Menu, Baud Rate
1. Select Baud Rate, then tap PGM.
Auto Baud displays. To select the baud rate, press
↓↓
. Available selections are, Auto Baud, 9600 Baud, or 76.8 Baud.
2. Tap PGM to select the baud rate.
3. Tap CLR to exit when finished.
The new baud rate is now set.
4. Run Service Menu, Save Cfg. to store the Baud Rate settings.
Service Menu, Dim
This item causes the speaker or headphone level to diminish by a specified amount whenever a talk key is activated.
1. Select Dim, and then tap PGM.
Speaker displays. To select headset, press
↓↓
or
↑↑
.
2. Tap PGM.
By default, -8dB displays for speaker, and 0dB displays for headset. This is the default amount of dimming.
3. Press ↑↑ to increase the amount of dimming. Press ↓↓ to decrease it.
4. Tap CLR to exit when finished.
The new dimming level is now set.
5. Run Service Menu, Save Cfg, to store the Dim setting.
Service Menu, Disply Dim
This item adjusts the alphanumeric display settings.
1. Select Display Dim, and then tap PGM.
Display Off displays.
2. Press ↓↓ or ↑↑ to select any of the following:
Display Off: Turns off the display. Any incoming call, or control movement, will reactivate the display.
Dim: Possibly a better choice when the ambient light level is low. Uses less power and increases display life.
Normal: Default medium brightness setting.
Bright: Good when ambient light is bright.
Matrix: Recommended only for very bright ambient light, such as outdoors. Uses maximum power and decreases display
life.
NOTE: For settings which change the operating brightness, run Service Menu, Save Cfg, page X, to store
the setting.
Service Menu, DSP Func (GPI Option Only)
This item accesses the digital signal processing features.
1. Select DSP Func, and then tap PGM.
Filtering displays. Press
↓↓
or
↑↑
to display any of the following items:
Filtering
Gating
Metering
Mixing
Refer to one of the following paragraphs for further information on the item that you select:
- USER INSTRUCTIONS 1
- Contents 3
- Introduction 9
- GPI Connector Module 10
- EKP-632 Expansion Keypanel 11
- LCP-632 Level Control Panel 11
- MCP-90 Panel Microphone 12
- Headsets 12
- Installation 13
- Address Switch Setting 14
- Address Setting for Zeus 15
- Address Setting for ADAM CS 15
- Connections 16
- Power Supply Connector 17
- Headset Connector 17
- Panel Microphone Connector 18
- Basic Operation 19
- Intercom Keys and Displays 20
- Listen LED Indication 21
- Intercom Key Operation 22
- Muting the Microphone 23
- Call Waiting Operation 24
- Telephone Operation 25
- KP9X Redial Sequence 26
- KP9X Autodial Sequences 26
- Manual Dialing 27
- Autodial 28
- Display Panel ID 29
- > Tap CLR to quit 29
- 1. Tap the E-PNL key 32
- 3. Tap the PGM key 32
- • Tap COPY 35
- Clearing a Key Assignment 35
- KP-632 Menu System 37
- Menu System, Key Assign Menu 39
- Key Assign Menu, Matrix 40
- Key Assign Menu, Pt-to-Pt 40
- Key Assign Menu, Party Line 40
- Key Option Menu 43
- Key Option Menu, Key Groups 44
- Key Option Menu, Solo 44
- RVON Conn. Menu 45
- Service Menu 45
- Service Menu, Baud Rate 46
- Service Menu, Dim 46
- Service Menu, Disply Dim 46
- Service Menu, Hdst Sel 48
- Service Menu, LCD Bright 48
- Service Menu, Matrix Out 51
- Service Menu, Mic Select 51
- Service Menu, Min Volume 51
- Service Menu, Mod Assign 51
- Service Menu, Output Level 52
- Service Menu, Reset Cfg 53
- Service Menu, Save Cfg 53
- Service Menu, Scr Saver 53
- Service Menu, Sidetone 54
- Service Menu, Snoop Tally 54
- Service Menu, Test Panel 54
- Service Menu, Tone Gen 54
- Specifications 55
- Speaker Amplifier and Speaker 56
- KP9x Display Sequences 63
- KP9x Setup Page Assignment 64
- KP9x Phone Operation 65
- Menu Access 67
- Menu List 68
- Mode 2 Operation 69
- Glossary 71
- Features 77
- Dip Switches 79
- Addresses and the RVON-1 82
- Top Level Menu, Rvon Conn 84
- Basic Network Configuration 87
- Wide Area Network 89
- TABLE 4. Packet Translation 90
- TABLE 5. Packet Translation 90
- IP Addresses 92
- Ping a Computer 93
- RVON Configuration 95
- Network Terminology 96
- • Backcard DB-9 J2 98
- Press Enter 100
- 3. Press Enter 101
Související produkty a manuály pro Systémy intercom pro domy RTS Cstrunk
Systémy intercom pro domy RTS CIF-612 Specifikace
(72 stránky)
(72 stránky)
Systémy intercom pro domy RTS TR-240 Specifikace
(86 stránky)
(86 stránky)
Systémy intercom pro domy RTS XCP-24 Servisní příručka
(114 stránky)
(114 stránky)
Systémy intercom pro domy RTS TR-240 Specifikace
(20 stránky)
(20 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.059 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce