RTS XCP-48-RJ45 Uživatelský manuál stáhnout pdf (Strana 30)

Ethernet Setup for Cronus

9. Connect the PC to you network with an Ethernet cable.

Once you have entered the IP Address and Network Mask, do the following:

1. From the Options menu, select Communications.

The Communications screen appears.

2. In the Connection area, select the Network radio button.

3. In the IP Address field, either enter the Cronus IP Address you wish to connect with, or click the Search button.

The search button scans the network for any Cronus devices. If multiple units are on the network, each will appear in the

list. Select the Cronus you wish to work with.

4. Click OK.

The Communications screen closes.

Download Firmware for Cronus

When firmware is downloaded to Cronus, all the code is put on the Master Controller card. This includes code for the AIO

cards. Therefore, because the Master Controller downloads the firmware for the system and the code for the AIO cards, the

download time is extended while the Master Controller pushes the AIO code out to the appropriate cards.

NOTE: Cronus must have AZedit version 2.06.07 or later.

Also, every time the system is reset or rebooted, the Master Controller card will reload each of the AIO cards with the most

current version of code it is housing.

To download firmware to the Master Controller, do the following:

1. Open AZedit.

The Keypanels/Ports screen appears.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 53 54

Žádné komentáře

RTS XCP-48-RJ45 Uživatelský manuál Strana 30