RTS BP300 Servisní příručka

Procházejte online nebo si stáhněte Servisní příručka pro Systémy intercom pro domy RTS BP300. RTS BP300 Service manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 14
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
CP-300
&
TW-12
Belt-Pack
&
Interface
Two-Wire
System
INSTRUCTION
and
SERVICE
MANUAL
CA)
ClearCor®e
Intercom
systems
1111
17th
Street
*
San
Francisco,
California
94107
*
415-861-6666
CLEAR-COM
810044
TW/10-84
REV
B
Zobrazit stránku 0
1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - ClearCor®e

CP-300 & TW-12Belt-Pack & InterfaceTwo-Wire SystemINSTRUCTIONandSERVICE MANUALCA) ClearCor®eIntercom systems1111 17th Street * San Francisco,

Strany 2

IV. PARTS LISTINGCP-300 Belt-Pack Without Signal Optionpart # description qty.150048 capacitor, lOOpF 1kv 20% RF 1210002 input connector, 3-pin female

Strany 3

V. CP-300 SPECIFICATIONSAMPLIFIER DESIGN: Solid-state, low-noise I.C. amps; current-limited and short-circuit-protected, with reverse polarity protect

Strany 4

[1 1 1CD0 : cn woo zT, -*0) La~~~~~~~~~L0 < n , cl e11 £ < X .12 , 111Li~~~~~~~±cU F- ~ U-+1~~~~~~~~~~~~~~~~*NOV 0 0L.J~ ~ ~~~~L0~~~~~~~~

Strany 5

Xt ,Y~~~~kbo,..3~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~f g-' 0,__--a -oowi~~~~~~~~~~~~~~~~~~~~~~~~~~e~ W vr L, 9 d..I.28... __ ___% v < N

Strany 6 - 2-CHrmode

_ _ _ _ _ _ _ _ _ _ U -, ~~~~~~~~~~~~~~~~~~~~~~~~~~~~S INa3llgf~~~~~~~~etc1 ~~~~~~~~~~~L N1,> ,m 1- ~1Lj~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Strany 7 - Belt-Pack

CLEAR-COM CP-300 BELTPACK STATION& TW-12 TWO-WIRE INTERFACE UNITOPERATION & SERVICE MANUALContents Page #Introduction to the Belt-Pack & I

Strany 8 - K~~~~~~~~~~~~~

CLEAR-CON CP-300 BELT-PACKOperation & Service ManualADDENDACP-300 "Call" Signalling(replaces "Optional Signalling" section of

Strany 9

CLEAR-COM CP-300 BELT-PACK STATION & TW-12 INTERFACE UNITOPERATION MANUAL.1. INTRODUCTION TO THE BELT-PACK & INTERFACEThe Clear-Com CP-300 is

Strany 10

CP-300 and TW-12 Description, continuedThe belt-pack provides a sidetone The TW-12 can also be used to link 0adjustment, which allows the user the Cle

Strany 11

II. SYSTEM INSTALLATIONHeadsetsThe CP-300's dynamic headset input is a 4-pin, male XLR.To insure proper level and performance, the dynamic headse

Strany 12 - 0~~~~~~~~~~~~~L

SYSTEM INSTALLATION, continuedThe CP-300 as a Single-Channel StationFirst be sure that the recessed two-position switch on thebelt-pack's side is

Strany 13 - O zo T

SYSTEM INSTALLATION, continuedTW-12 Set-UpThe TW-12 provides two male and two female 3-pin, XLR conned-tors for input and extension of Clear-Com chann

Strany 14 - N1,>

111. CP-300 OPERATING CONTROLSThe MIC SWITCH turns the headset signals. To re-set it, locate themic ON and OFF, and includes a unmarked hole (which co

Komentáře k této Příručce

Žádné komentáře