RTS XCP-48-RJ45 Uživatelský manuál stáhnout pdf (Strana 81)

Appendix C

RVON-C Quick Start

This guide explains briefly how to install and configure an RVON-C card in a Cronus system. It contains the following

sections

1. Install the front card and the back card into Cronus.

2. Connect Ethernet

3. Connect to Cronus frame in AZedit

4. Configure the RVON-C card

5. Configure the devices the card will connect with

6. Begin Operation.

NOTE: If you are connecting using Serial Pass-Through Port, See “RVON-C Card Serial Port Programming” on page 69.

Install Front and Back Cards in Cronus

When inserting the RVON-C card into Cronus, the following considerations need to be made:

• Gently insert the RVON-C card into the correct slot. If the card is forced or twisted while inserting, a pin on the

backplane could short or break causing the card to become inoperable.

• When inserting the RVON-C card into Cronus, be sure to insert it into a compatible back card. If the card is

inserted into an incompatible back card, undesirable results can occur.

Plug in Ethernet

Verify there is an Ethernet connection from the RVON-C card (J2 Ethernet on the back of the Cronus) to the network.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 106 107

Žádné komentáře

RTS XCP-48-RJ45 Uživatelský manuál Strana 81