RTS KP-97 Servisní příručka stáhnout pdf (Strana 11)

☞

Note that 9-pin intercom cables for use with an

ADAM CS frame must use special connectors at the

intercom matrix end as shown in Figure 4.

2.7 OPTIONAL CONNECTIONS

☞

The following connections require an optional

KP96-RC Rear Connector Panel on the back of the

keypanel.

2.7.1 Expansion Panels and LCP-100A

Figure 6 shows optional connections when using expan-

sion panel and / or level control panels with the keypanel.

Use the cables supplied with the panels. A maximum of

two expansion panels and three level control panels may

be connected.

Installation Instructions, KP96 / KP97 Series Keypanels 11

DE-9P (MALE)

TO KEYPANEL

DE-9S (FEMALE)

TO INTERCOM SYSTEM*

CABLE TYPE:

BELDEN 8777

DATA

AUDIO TO MATRIX

AUDIO FROM MATRIX

When connecting to an ADAM CS back panel, use

only low-profile cable connectors such as AMP

Part No. 747516-3 (Telex Part No. 59926-678)

IMPORTANT!

Figure 4. 9-pin Intercom cable wiring diagram

Pin Function

1 RS422 Data “+”

2 RS 422 Data “-”

3 Ground , Shield

4 Audio Output “+”

5 Audio Output “-”

6 Ground, Shield

7 Audio Input “-”

8 Audio Input “+”

9 Ground

Table 2. 9-pin FRAME Connector Pin-out

Pin Function

1 RS422 Data “-”

2 Audio Input “+”

3 Audio Output “+”

4 Audio Output “-”

5 Audio Input “-”

6 RS422 Data “+”

Table 3. RJ-11 FRAME Connector Pin-out

3 TWISTED PAIR TELEPHONE CABLE

DATA -

AUDIO FROM MATRIX +

AUDIO TO MATRIX -

DATA +

123456

CONTACTS

LATCH

RJ 11 MOD PLUG

AMP 55550423 or equivalent

(View from cable entrance)

Use AMP Crimp Tool

12316661

PAIR 1: AUDIO TO MATRIX

PAIR 2: AUDIO FROM MATRIX

PAIR 3: DATA

AUDIO FROM MATRIX -

AUDIO TO MATRIX +

Figure 5. RJ-11 Intercom cable wiring diagram

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Komentáře k této Příručce

Žádné komentáře

RTS KP-97 Servisní příručka Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Systémy intercom pro domy RTS KP-97