RTS TM-2000 Uživatelský manuál stáhnout pdf (Strana 33)

Since the PS15’s internal termination is not used in this

application, the position of the Impedance Select switch

on the back panel does not matter. On the SSA-324,

switches S101 and S102 on the back panel should be set

to the Unbal position. The System A and System B

switches on the front panel should be set to CH2. For each

Zeus channel, you can start with the default analog input /

output settings. Adjust the level going from Zeus to each

belt pack using the Level to RTS trimmer on the front of

the SSA-324. Adjust the level from the belt pack to Zeus

with the Level from RTS trimmer. In this application, you

will probably leave the SSA-324 Duck trimmers in the

full clockwise position. The Null Low, Med and Hi trim-

mers can be adjusted to minimize the belt pack users own

voice in the belt pack headphones.

Getting Started, Zeus™ DSP Intercom Matrix 31

HEADSET LINESHEADSET LINES

2-Wire

In / Out

J101

Powe r

Input

TB 1 Connections

System B

S101

Sys B

BAL

Unbal

In = Bal

87654321

TB 1

Fuse

1A SB

System A

1 - 4-Wire in Hi

2 - 4-Wire in Lo

3 - 4-Wire Out Hi

4 - 4-Wire Out Lo

System B

5 - 4-Wire in Hi

6 - 4-Wire in Lo

7 - 4-Wire Out Hi

8 - 4-Wire Out Lo

S102

Sys A

BAL

Unbal

2-Wire

In / Out

System A

J102 J104

TELEX COMMUNICATONS, INC. Made in the U.S.A. TW Intercom System Mode SSA324 System Interface

1 - Earth

2 - AC

3 - AC

4 - NC

PUSH PUSH

J103 I/O

MODEL PS15

POWER SUPPLY

O/N 9000678600

IMPEDANCE

SELECT

NORM

200

Ω

DUAL

400

Ω

OUTPUTS

J1, J2 CONNECT TO

TW INTERCOM SYSTEM COMPONENTS

REFER TO OPERATION MANUAL

AUDIO

COUPLING

CH1-CH2

CAUTION

FOR CONTINUED PROTECTION AGAINST FIRE,

REPLACE ONLY WITH SAME TYPE FUSE.

FUSE

0.5A SB / 120VAC

0.25A SB / 240VAC

TIP-CH1

RING-CH2

SLEEVE-COM

RTS SYSTEMS, BURBANK, CALIFORNIA MADE IN U.S.A.

PUSH

To a Zeus Channel

To Another

TW5W

PS15

TW5W TW5W

BP-318BP-318

SSA-324

Figure 27. Interfacing TW Belt Packs to Zeus

The numbered callouts are the Figure numbers for cable wiring diagrams starting on page 22. On the PS15: the position of the

Impedance Select switch does not matter. On the SSA-324: set switches S101 and S102 to the Unbal position; set the front

panel System A and System B switches to CH2.

21 21

1 2 ... 28 29 30 31 32 33 34 35 36 37

Komentáře k této Příručce

Žádné komentáře

RTS TM-2000 Uživatelský manuál Strana 33

Komentáře k této Příručce

Související produkty a manuály pro Systémy intercom pro domy RTS TM-2000