RTS TM-2000 Uživatelský manuál stáhnout pdf (Strana 13)

CHAPTER 2

Installation

Installing Software

There are two software packages that can be used with an external PC connected to the TM-2000/MTM-2000. The TrunkEdit

software package is included with the TM-2000/MTM-2000 system. This package provides the user with the ability to

program (configure) and monitor the TM-2000/MTM-2000. The other software package, called TrunkSupervisor, is available

as a separate add-on at an additional cost. TrunkSupervisor is an advanced monitoring package for trunked systems.

Both packages require the following minimum system:

• Windows

95 with Internet Explorer 4.01 SR2 or higher

• 64MB Memory

• 20MB Free Hard Disk space (not including swap file)

• TrunkEdit: One free serial (COM) port

• TrunkSupervisor: One free serial (COM) port, or two free serial (COM) ports if an AutoTIMS unit is to be

monitored.

NOTE: A minimum of two serial ports are required to run both software packages at the same time on the same

computer. Three serial ports are required if an AutoTIMS unit is to be monitored by TrunkSupervisor.

TrunkEdit works with a PC attached to COM port 1 of the TM-2000/MTM-2000 or via the TRK EDIT port of the SWP-2000.

TrunkSupervisor works with a PC attached to COM port 2 of the TM-2000/MTM-2000 or via the TRK SPVR port of the

SWP-2000. See Figure 1 on page 4 for an example of how COM port 1 and 2 are labeled on the TM-2000/MTM-2000.

Rack Mounting

Install the TM-2000(s)/MTM-2000(s), ICP-2000(s), and SWP-2000 (if used) in the equipment rack. The units do not have

special ventilation requirements. If a redundant system is being configured it is recommended that the SWP-2000 be installed

between the two TM-2000(s)/MTM-2000(s). Mount the ICP-2000 panel(s) either above or below the TM-2000(s)/MTM-

2000(s).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Žádné komentáře

RTS TM-2000 Uživatelský manuál Strana 13