RTS TM-2000 Uživatelský manuál stáhnout pdf (Strana 15)

Bosch Security Systems, Inc.

User Manual

F.01U.193.264

Rev. 12

CHAPTER 2

Installation

Installing Software

There are two (2) software packages that can be used with an external PC connected to the TM-2000/MTM-2000. The

TrunkEdit software package is included with the TM-2000/MTM-2000 system. This package provides the user with the ability

to program (configure) and monitor the TM-2000/MTM-2000. The other software package, called TrunkSupervisor, is

available as a separate add-on at an additional cost. TrunkSupervisor is an advanced monitoring package for trunked systems.

Both models need the following minimum system requirements:

• Windows

95 with Internet Explorer 4.01 SR2 or higher

• 64MB Memory

• 20MB Free Hard Disk space (not including swap file)

• TrunkEdit: One (1) serial (COM) port

• TrunkSupervisor: One (1) serial (COM) port, or two (2) serial (COM) ports if an AutoTIMS unit is to be

monitored.

NOTE: A minimum of two (2) serial ports are required to run both software packages at the same time on the same

computer. Three (3) serial ports are required if an AutoTIMS unit is to be monitored by TrunkSupervisor.

TrunkEdit works with a PC attached to COM port 1 of the TM-2000/MTM-2000 or via the TRK EDIT port of the SWP-2000.

TrunkSupervisor works with a PC attached to COM port 2 of the TM-2000/MTM-2000 or via the TRK SPVR port of the

SWP-2000. See Figure 1 on page 4 for an example of how COM port 1 and 2 are labeled on the TM-2000/MTM-2000.

Rack Mounting

IMPORTANT: Install the TM-2000(s)/MTM-2000(s), ICP-2000(s), and SWP-2000 (if used) in the equipment rack.

The units do not have special ventilation requirements. If a redundant system is being configured, it is

recommended the SWP-2000 be installed between the two (2) TM-2000(s)/MTM-2000(s). Mount the

ICP-2000 panel(s) either above or below the TM-2000(s)/MTM-2000(s).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Žádné komentáře

RTS TM-2000 Uživatelský manuál Strana 15