RTS TR-240 Provozní pokyny Strana 16
- Strana / 65
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Antenna Connection
The base station is supplied with two (2) antennas. One
1/2-wave antenna for Transmit and one 1/2-wave for Receive.
The antennas have TNC male connectors.
The frequency range of the antennas should match the receiver
and transmitter of the base station. Match the color code on
the antenna with the color code on the base station.
Attach the transmit 1/2-wave antenna to the antenna input re
-
ceptacle labeled “Transmit” on the right side of the rear panel.
The antenna should be vertically aligned.
Figure 7
Attaching Transmit 1/2-Wave Antenna
Attach the receive 1/2-wave antenna to the antenna input re-
ceptacle labeled “Receive” on the left side of the rear panel.
The antenna should be vertically aligned.
Figure 8
Attaching Receive 1/2-Wave Antenna
Antenna Polarization
The Telex Wireless Intercom System is “Vertically Polarized”.
This means both the transmitting and receiving antennas
should operate in the vertical position.
Figure 9
Vertically Polarized Antennas
Distance between Antennas
The distance between the base station’s receive and transmit
antennas is not adjustable when the antennas are connected di
-
rectly on the back of the unit.
The antennas can be remoted for better signal path. A Telex
coax assembly with remote antennas may be required. See
“Accessory” section for ordering information.
NOTE: If your base station is to be located in a shielded rack
mount enclosure or other poor RF location, you must remote
the 1/2-wave antennas with coax assemblies. See “Accessories
and Replacement Parts” section for remote mounting hard-
ware.
Antenna Placement
Proper antenna placement probably has the most effect on
your TELEX Wireless Intercom System’s overall perfor-
mance. The following suggestions will result in optimum per-
formance.
Proper placement of the beltpack can be critical. The antennas
should be in the open. Bending the antennas up and placing
the beltpack in a pocket, etc., will reduce system distance.
It is suggested that the unit be worn on the belt or pocket with
both antenna’s vertical for best operating range and perfor
-
mance.
Figure 10
Proper Dressing of the Antennas
4-2
T
e
l
e
x
O
F
F
B
A
T
/
O
M
T
A
L
K
R
a
d
i
o
C
o
m
T
R
-
7
0
0
T
M
VOL
MICGAIN
TALK/O.M.
VOLUME
ON/O.M.
ON/OFF
IN
OUT
AUXILIARY
2WIRE
4WIRE
SELECT
IN
OUT
PORTABLESTATION CONNECT
12
3
4
UP
DOWN
MENU
SET
RadioCom
ä
ClearScan
TM
COPY
INTERCOM
BTR-700
TALK
ANTENNAS SHOULD BE VERTICAL
T
e
l
e
x
O
F
F
B
A
T
/
O
M
T
A
L
K
R
a
d
i
o
C
o
m
T
M
VOL
TR-700
- RadioCom 1
- Table of Contents 3
- Table of Contents (continued) 4
- Introduction 5
- BTR-700 Block Diagram 6
- BTR-700 Base Station 7
- INTERCOM 8
- 2-4 Blank 10
- TR-700 Beltpack 11
- RTS Units 12
- Telex Units 12
- Specifications 13
- 3-4 Blank 14
- Initial Equipment Set-Up 15
- 100 FEET 17
- 700 FEET 17
- Base Station Set-up 19
- Location 19
- Power Connection 19
- Transmit Switches 19
- Intercom Switch 20
- Intercom Interface 20
- FCC ID: B5DM516 21
- CANADA 1321231218A 21
- TELEX COMMUNICATIONS INC 21
- MADE IN USA 21
- Beltpack Set-up 22
- Battery Installation 22
- Antenna Connection 23
- Transmit mode 23
- Headset Connection 23
- 4-10 Blank 24
- Pre-Walk-Thru Checklist 25
- 5-2 Blank 26
- System Operation 27
- Display Contrast 29
- ClearScan 30
- Group / Channel Select 32
- Group / Frequency Select 33
- Frequency Edit 34
- Beltpack Operation 37
- Power / Local Headset Volume 37
- Battery Check 37
- Talk Button 37
- Microphone Gain 37
- TR-700 Menu Structure 38
- Beltpack Menu Structure 38
- Power-Up Screens 39
- Group / Channel Screen 40
- Transmit Screen 41
- Receive Screen 42
- ClearScan™ 43
- HOLD [SET] AND PRESS [TALK] 44
- RELEASE [SET] 44
- CONTINUE TO HOLD [SET] 44
- AND PRESS [TALK] AGAIN 44
- System Walk-Thru 45
- 7-2 Blank 46
- Troubleshooting 47
- 8-2 Blank 48
- Tech Tips 49
- 9-2 Blank 50
- Battery Information 51
- 10-2 Blank 52
- AUDIO(-)PLUSPOWER 53
- AUDIO ( + ) PLUS POWER 53
- 11-2 Blank 54
- MICROPHONE STAND 55
- MOUNTING 55
- 12-2 Blank 56
- Customer Service Information 57
- 13-2 Blank 58
- Software License 59
- 14-2 Blank 60
- Certification Information 61
- 15-2 Blank 62
- Limited Warranty 63
- 16-2 Blank 64
- TELEX COMMUNICATIONS, INC 65
Související produkty a manuály pro Systémy intercom pro domy RTS TR-240
Systémy intercom pro domy RTS Cstrunk Specifikace
(104 stránky)
(104 stránky)
Systémy intercom pro domy RTS CIF-612 Specifikace
(72 stránky)
(72 stránky)
Systémy intercom pro domy RTS TR-240 Specifikace
(86 stránky)
(86 stránky)
Systémy intercom pro domy RTS XCP-24 Servisní příručka
(114 stránky)
(114 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.100 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce