RTS RVON-I/O Uživatelský manuál stáhnout pdf (Strana 15)

6. Using Telnet or Serial programming (see ), configure the RVON-I/O as follows:

NOTE: To see actual Telnet commands, see “RVON-I/O Command Table” on page 25.

set channel [chan]

dest ip_addr (IP Address of the RVON-1, RVON-8, or RVON-I/O that is connected to the RVON-I/

dest_type (the type of device, either an RVON-1, RVON-8, or RVON-I/O)

dest_chan

dest_codec (optional)

7. Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the

configuration setup on the RVON-I/O

Basic Remote Mode Setup

In Remote Mode, the keypanel with RVON-1 installed is directly connected to the RVON-I/O via Ethernet.

To setup a basic remote mode system, do the following:

1. On the back of the RVON-I/O, put DIP switch 1 in the CLOSED position (Remote Mode).

2. Power ON the RVON-I/O unit.

3. Connect the matrix system to the RVON-I/O (I/O ports), using a DB-9 crossover cable. See page 5 for the different

connection diagrams.

4. Connect the RVON-I/O to Ethernet.

5. Set the IP Address for the RVON-I/O (see “Setup IP Addresses” on page 17).

6. Using Telnet or Serial programming (see “RVON-I/O Command Table” on page 25), configure the RVON-I/O as

follows.

NOTE: To see actual Telnet commands, see “RVON-I/O Command Table” on page 25.

set channel [chan]

dest ip_addr (IP Address of the RVON-1, RVON-8, or RVON-I/O that is connected to the RVON-I/

dest_type (the type of device, either an RVON-1, RVON-8, or RVON-I/O)

dest_chan

dest_codec (optional)

set panel [panel]

poll_id (see “Set Panel” on page 32)

baud

7. Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the

configuration setup on the RVON-I/O.

NOTE: If you do not have a RVON-1 pre-installed, the KP-32 or the KP-812 must have the RVON-1 component

installed prior to Remote setup (See the RVON-1 User Manual for details).

RVON-I/O Trunk Setup

When trunking two intercom systems over Ethernet using RVON-I/O, you can setup the RVON-I/O on both ends of the trunks

in either LOCAL or REMOTE mode. However, a REMOTE to REMOTE mode system is the preferred way of trunking.

To setup remote mode in a trunked system, do the following:

1. On the back of the RVON-I/O, put DIP switch 1 in the CLOSED position (Remote Mode).

2. Power ON the RVON-I/O unit.

3. Connect the Matrix to the RVON-I/O (via I/O ports), using a DB-9 crossover cable. See page 5 for the different

connection diagrams.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Žádné komentáře

RTS RVON-I/O Uživatelský manuál Strana 15